LIFEPAK CR Plus AED Featuring the same advanced technology trusted by emergency medical professionals—yet simple to use—the fully-automatic LIFEPAK CR® Plus AED is designed specifically for the first person to respond to a victim of sudden cardiac arrest.
Simple to Use
- Simple to turn on
- Simple to find, remove and place electrodes correctly
- Simple to deliver therapy—no shock button to push
- Simple to increase the chance for survival by automatically escalating energy up to 360 joules if needed*
Simple to Own
- The CR Plus comes ready to use: Initial purchase includes carry case, extra electrodes, Charge-Pak™ battery charger and Ambu® Res-Cue Mask® Kit
- Lowest total cost of ongoing ownership in the AED industry
- Simple transition to EMS teams who also use LIFEPAK products
Simple to Maintain
- One of the longest warranties in the industry at 8 years
- Synchronized Charge-Pak battery charger and electrode replacement cycle
Simply put... The LIFEPAK CR Plus automated external defibrillator from Physio-Control is
the effective, safe and affordable choice.
Waveform: Biphasic truncated exponential, with voltage and current duration compensation for patient impedance.**
Output Energy Sequence: Multiple levels, configurable from 150 joules to 360 joules (200 joules min for Japan). Factory default settings of 200J, 300J, 360J.
Output Energy Accuracy: ±10% into 50 ohms, ±15% into 25 to 100 ohms.
Shock Advisory System: An ECG analysis system That advises whether a shock is appropriate; meets rhythm recognition criteria specified in DF39.
The device charges for shock only when the Shock Advisory System advises defibrillation.
Device Capacity: Typical: Thirty (30) full discharges or 210 minutes of “on time” with a fully charged device.
Minimum: Twenty (20) full discharges or 140 minutes of “on time” with a fully charged device.
Shock Charge Time: Charge times with a fully
charged device: 200 joules in less than 9 seconds, 360 joules in less than 15 seconds.
System Recharge Times: Recharge times with a fully discharged device: Able to deliver 6 shocks or provide 42 minutes of operating time after 24 hours of recharge time and 20 shocks or 140 minutes of operating time after 72 hours of recharge time with a new CHARGE-PAK at temperatures above 15° C (59° F).
Controls: Lid Release/ON-OFF—Controls device power. Shock button (semi-automatic version)—delivers defibrillation energy. After electrodes are attached to a patient, the fully automatic version of the device delivers a shock, if appropriate, not requiring operator intervention.
Electrical Protection: Input protected against high voltage defibrillator pulses per IEC60601-1/EN60601-1.
Safety Classification: Internally powered equipment. IEC60601-1/EN60601-1.
Height: 10.7 cm (4.2 in).
Width: 20.3 cm (8.0 in).
Depth: 24.1 cm (9.5 in), excluding handle.
Weight: 2.0 kg (4.5 lb) with CHARGE-PAK and electrodes
User Interface: The user interface includes voice prompts, audible tones and graphic prompts.
Readiness Display: The readiness display shows the device status. OK Indicator: Shows “OK” when the last self-test was completed successfully. When the “OK” indicator is visible, all other indicators are not visible. The “OK” indicator is not displayed during device operation.
Charge-Pak Indicator: When displayed, replace the Charge-Pak™ battery charger.
Attention Indicator: When first displayed, at least six (6) discharges or 42 minutes of operating time remain.
Service Indicator: Service required when displayed.
Note: All performance specifications defined assume the unit has been stored (two hours minimum) at operating temperature prior to operation.
Operating Temperature: 0° to +50° C (+32° to +122° F).
Storage Temperature: -40° to +70° C (-40° to +158° F) with Charge-Pak and electrodes, maximum exposure time limited to one week.
Atmospheric Pressure: 760 mmHg to 429 mmHg, 0 to 15,000 feet above sea level.
Relative Humidity: 5 to 95% (non-condensing). Water Resistance: IEC60529/EN60529 IPX4 “Splash proof” with electrodes connected, chargepak installed.
Shock: MIL-STD-810E, Method 516.4, Procedure 1, (40g, 6-9 ms pulse, 1/2 sine each axis).
Vibration: MIL-STD-810E, Method 514.4, Helicopter - category 6 (3.75 Grms) and Ground Mobile - category 8 (2.85 Grms).
Energy Sequence: Energy sequence is set to 200J, 300J, 360J.
Motion Detection: The motion detection system is set to on during analysis.
Energy Protocol: The energy protocol is set to increase energy only after a lower energy shock was unsuccessful.
Stack Shocks: Stack shocks option is set to off. Turn-On Prompt: The turn-on prompt is set to provide voice prompts upon power on.
CPR Time: The CPR Time is set to 120 seconds.
Voice Prompt Volume: The voice prompt volume is set to high.
CHARGE-PAK Battery Charger
Type: Li/SO2Cl2 Lithium Sulfuryl Chloride, 11.7V, 1.4 amp-hours.
Replacement: Replace the CHARGE-PAK battery charger and QUIK-PAK™ electrodes packet after using the defibrillator, if the CHARGE-PAK symbol appears in the readiness display or when the Use By date is reached (typically 2 years).
Weight: 80.5 grams (0.18 lb).
QUIK-PAK Electrode Pads
Pads: ECG is received from disposabledefibrillation electrodes, standard placement (anterior-lateral).
Pads Packaging: User intuitive, rapid release Quik-Pak electrodes allow the electrode pads to be preconnected to the device and protected under a top cover.
Pads Replacement: Replace every two (2) years. Infant/Child Reduced Energy Defibrillation
Electrodes: For use on infants and children less than 8 years of age or less than 55 lbs (25kg).
Memory Type: Internal digital memory.
ECG Storage: Dual patient data storage. Minimum 20 minutes of ECG stored for the current patient, summarized data stored for the previous patient.
• Continuous ECG – A continuous patient ECG report.
• Continuous Summary report – A summary of critical resuscitation events and ECG waveform segments associated with these events.
• Event Log report – A report of time stamped markers, which reflect operator and device activity.
• Test Log report – A device self-test activity report.
Capacity: Minimum 200 time-stamped event log markers.
Communications: Wireless transfer to a personal computer.
Data Review: Physio-Control provides an array of tools to meet customer needs for data viewing and
** The specifications apply from 25 to 200 ohms. Voltage compensation is limited to the voltage that would result in delivery of 360 joules into 50 ohms.